VEGA VIB S61系列振動開關產品數據表

VEGAVIB S 61

Vibrating level switch for granulates

• Easy setup without adjustment
• Product-independent switching point
• Optimum rod design avoids buildup and jamming
• Easy cleaning
• Wear and maintenance free

Function

The vibrating rod of VEGAVIB is energized by a piezo crystal and it vibrates at a fixed amplitude. If the vibrating rod is covered by product, the amplitude change is detected by the integral electronics and converted into a switch signal. The switching condition is visible from outside via a two colour LED. No special adjustments are required to set up VEGAVIB S 61.

Area of application

VEGAVIB S 61 is used as a level switch in free flowing powders, granulates and coarse grained solids and detects reliably and accuray when a point level is reached. The optimum rod design avoids jamming and buildup of bulk solid material. It is ideal as a high or low level switch in a vessel detecting foodstuffs, perishable or granulate materials,which could be retained in a fork solids level probe.

Technical data

 Process pressure  -1…16 bar

 Process temperature  -50…+150℃

 Density  ≥ 100 g/l

 Material housing  plastic PBT

 Protection  IP 66/IP 67

 Materials, wetted parts  316L

 Approval  option: ATEX II 1/3 D IP6X T

 Electronics transistor (NPN/PNP)

 Load current  max. 400 mA

 Turn-on voltage  max. 55 V DC

 Supply voltage  10…55 V DC

 Power consumption  max. 0.5 W

 Electronics double relay (DPDT)

 Supply voltage 20…253 V AC,50/60 Hz,20…72 V DC

 Power consumption 1…8 VA (AC),approx. 1.3 W (DC)

 Turn-on voltage min. 10 mV / max. 253 V AC/DC

 Switching current min. 10 μA/ max. 3 A AC, 1 A DC

 Breaking capacity max. 750 VA, 54 W

Accessories:Sliding lock fitting (extended versions) pressurised or unpressurised for adjustable switch point

VEGAVIB S 61

振動極限開關，用于顆粒狀的固料

l   安裝方便, 無需調整

l   產品獨立開關點

l   優化桿設計避免了堆積和干擾

l   易清洗

功能

VEGAVIB 的振動桿由壓電晶體激發, 并以固定振幅振動。如果振動桿被產品覆蓋, 則通過整體電子學檢測振幅變化并轉換成開關信號。開關情況從外面是可看見的通過LED指示燈顯示。設置 VEGAVIB S 61 不需要進行特殊調整。

應用領域

VEGAVIB S 61 在自由流動的粉末、顆粒和粗粒固體中被用作電平開關, 并在達到點水平時進行可靠和準確的檢測。*桿設計避免了大塊固體材料的干擾和堆積。它是理想的作為一個高或低電平開關的船舶檢測食品, 易腐或粒材料, 這可以保留在一個叉子固體水平探頭。

技術資料

工藝壓力-1..。16 bar

工藝溫度-50... + 150℃

密度≥100克/升

材料外殼塑料 PBT

保護 ip 66/ip 67

材料, 濕部316L

批準選項: ATEX II 1/3 D IP6X T

電子晶體管 (NPN/PNP)

負載電流zui大值400 mA

開啟電壓zui大值55 V DC

電源電壓 10…55 V DC

功耗zui大值0.5 W

電子雙繼電器 (雙)

電源電壓20…253伏 AC, 50/60 赫茲, 20…72 V DC

功耗 1…8 VA (AC), 約 1.3 W (DC)

開啟電壓zui小10毫伏/zui大 253 V 交/直流

開關電流zui小 10 a/zui大值3 a AC, 1 DC

容量750 VA, 54 W

附件: 滑動鎖配件 (擴展版) 加壓或 unpressurised 可調開關點

以上即為VEGA VIB S61 6263的相關介紹，如有任何技術咨詢或需要相關技術資料，請前往上海愛澤工業設備有限公司相關頁面進行下載。